Need help on how to enlargen the sprite size yet the VX can be able to read the sprite.
When I tried enlargening it, the VX only read a smaller part of the picture. Need helppp

post the sprite sheet and i'll enlarge it for you.

Right outta the help file...

Characters (Graphics/Characters)

These files contain character graphics for the map screen.

The size for 1 character includes 4 directions (down, left, right, and up) and 3 patterns for a total of 12 patterns in a set order. One file should contain 2 characters vertically and 4 horizontally, for a total of 8 characters. The size of one character is calculated to be 1/12 the width and 1/8 the height of this file.

Note that in order to make overlapping with buildings appear more natural, characters are displayed 4 pixels above the tiles.


• You can disable this effect by putting a "!" at the beginning of the file name. This is mainly used for object-type characters on the map, such as doors and treasure chests. It is possible to use this in conjunction with the special symbol "$".
• If you put a "$" at the beginning of the file name, only one character per file will be used. In this case, the character size is 1/3 the width and 1/4 the height of the file. It is possible to use this in conjunction with the special symbol "!".

if your file only contains 1 character, unlike the RTP character sets that contain 8 characters, put a $ in front of the name:

$my_character.png

Thanks, here are the sheets.
I really appreciate your help ^^

did u want to make an individual picture bigger so the sprites are like huge so they are huge in game?

Yeah I was going to say, just increase the size of the picture in Paint even to how big you want it, then import it back again. Easy.

whoops. completely forgot about this. give me half a sec.

*2 minutes later.....*